Error
  • JLIB_CACHE_ERROR_CACHE_STORAGE_LOAD
  • JLIB_CACHE_ERROR_CACHE_STORAGE_LOAD
  • Unable to load Cache Storage: cachelite
  • Unable to load Cache Storage: cachelite
  • Unable to load Cache Storage: cachelite
  • Unable to load Cache Storage: cachelite
How To Add An Lining To Ready Made Curtains

How To Add An Lining To Ready Made Curtains



Curtains finish the look of the room they hang in and add to. In the winter time it's nice to have thick, lined curtains. You had like to have them lined and in case your favored drapes are not thick there is custom changed, or no demand to possess them done. You are able to add a lining to any panel design curtain yourself. All you need are a sewing machine along with the appropriate equipment.



-- Use a tape measure to quantify afterward length and the width of the drape that is ready made. Add 1 inch to the length and width measurements to know how large the liner must be.
-- Lay the lining face back in your work surface. Be sure it is straight and smooth, the span horizontal and the width vertical. Make use of straight edge, a tape measure, and material marking pen to quantify and mark the backside of the liner in line with the measurements you require. Make the line clear and dark so you'll have certain lines to cut.
-- Cut on the lining to size using sharp fabric cutting scissors.
-- Lay the lining face down once it has been cut to size. Fold the top side of the lining down 1/2 inch. Fasten using common pins every 3 inches, also called straight pins,. Don't pin the corners as the sides will undoubtedly be pinned in the corners. Fold the bottom side upward 1/2 inch, fasten with pins. Fold the side edges secure.
-- Use a sewing machine to stitch all pinned edges. Stitching twice is unnecessary as the seam will be stitch if it is attached to the ready made drape. Remove all pins when you're finished stitching.
Lay the liner on the drape, equally, face down. Fasten all edges together by fitting pins every 2 inches. Secure the lining to the curtain by adding the pin down through the lining and to the curtain, then through the drape and the liner 1/4 to 1/2 inch over from where the pin was inserted.
-- Use a sewing machine along with a colour of thread that matches or blends in with the shade of the front side of the ready made curtain. Stitch all seams twice for extra strength and durability. Remove and hang the curtain.

If you liked this write-up and you would like to get more information about dunelm.com sale kindly visit the page.